Monte Carlo V6-3.8L VIN K (1998)
3. Remove the automatic transaxle range selector cable from the bracket.
4. Remove the automatic transaxle range selector cable bracket bolts.
5. Remove the automatic transaxle range selector cable bracket.
INSTALLATION PROCEDURE
1. Install the automatic transaxle range selector cable bracket.
2. Install the automatic transaxle range selector cable bracket bolts.
^
Tighten the automatic transaxle range selector cable bracket bolts to 25 Nm (18 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the automatic transaxle range selector cable to the bracket.
