Monte Carlo V6-3.8L VIN K (1998)
7. Remove the automatic transaxle range selector cable from the console shift control.
8. Remove the automatic transaxle range selector cable through the hole in the cowl.
9. Remove the automatic transaxle range selector cable from the PNP switch. Refer to AT Range Selector Cable Replacement (At PNP Switch).
INSTALLATION PROCEDURE
CAUTION: The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two
metal couplings from one another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings
occurs. When servicing the transaxle remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range
selector cable bracket. If either section of the cable needs to be replaced, replace both of the cable sections. Loss of connection integrity of the
two metal couplings can cause loss of transaxle shift control which could result in personal injury.
1. Properly route and position the automatic transaxle range selector cable.
