Monte Carlo V6-3.8L VIN K (1998)
1. Install the automatic transaxle range selector cable bracket.
2. Install the automatic transaxle range selector cable bracket bolts.
^
Tighten the automatic transaxle range selector cable bracket bolts to 25 Nm (18 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the automatic transaxle range selector cable to the bracket
4. Install the automatic transaxle range selector cable to the automatic transaxle range selector lever.
5. Adjust the automatic transaxle range selector cable if necessary. Refer to AT Range Selector Cable Adjustment.
6. Install the throttle body air inlet duct. Refer to Powertrain Management.
Shift Control Replacement
REMOVAL PROCEDURE
