Monte Carlo V6-3.8L VIN K (1998)
Shifter A/T: Service and Repair
4T60-E Automatic Transaxle
A/T Range Selector Cable Lever Replacement
REMOVAL PROCEDURE
1. Remove the throttle body air inlet duct. Refer to Powertrain Management.
2. Remove the automatic transaxle range selector cable from the automatic transaxle range selector lever.
3. Remove the automatic transaxle range selector lever nut.
4. Remove the automatic transaxle range selector lever.
INSTALLATION PROCEDURE
1. Install the automatic transaxle range selector lever.
2. Install the automatic transaxle range selector lever nut.
^
Tighten the automatic transaxle range selector lever nut to 20 Nm (15 ft. lbs.).