Monte Carlo V6-3.8L VIN K (1998)
2. Install the transaxle mount lower nuts to the transaxle mount frame bracket.
^
Tighten the transaxle mount lower nuts to 47 Nm (35 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the transaxle bracket to the transaxle. Refer to AT Mount Bracket Replacement.
A/T Mount Bracket Replacement
REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lift Points.
2. Remove the left front tire and wheel. Refer to Wheel Removal in Wheels and Tires.
3. Remove the left engine splash shield.
4. Use floor stands to support the transaxle.
5. Remove the transaxle bracket to transaxle mount upper nuts.
6. Remove the transaxle bracket to transaxle bolts.
7. Remove the transaxle bracket.
INSTALLATION PROCEDURE
1. Position the transaxle bracket to the transaxle.
2. Hand start the transaxle mount bracket to transaxle bolts.
3. Install the transaxle bracket bolts.