Monte Carlo V6-3.8L VIN K (1998)
Transmission Pressure Test Port: Service and Repair
4T60-E Automatic Transaxle
REMOVAL PROCEDURE
1. Remove the throttle body air inlet duct. Refer to Powertrain Management.
2. Remove the line the pressure pipe plug (38).
INSTALLATION PROCEDURE
1. Install the line pressure pipe plug (38).
^
Tighten the line pressure pipe plug (38) to 11 Nm (97 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the throttle body air inlet duct. Refer to Powertrain Management.