Monte Carlo V6-3.8L VIN K (1998)
Front Door - Coupe and Sedan
WINDOW REGULATOR
Front Door - Coupe and Sedan
NOTE: Coupe and sedan front doors use a cross arm regulator. The following procedures are required for removal and replacement of both power and
manual window regulators.
REMOVAL PROCEDURE
1. Remove the Door trim panel.
2. Remove the water deflector.
3. Remove the energy absorber pad (coupe only).
4. Remove the door window.
5. Disconnect the electrical connector, if equipped.
6. Remove the window regulator bolts (2).
7. Remove the window regulator cam nut.
8. Remove the rivets (2).
9. Remove the window regulator cam bolt.
10. Remove the regulator (1).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
