Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
1. Install the intake camshaft onto the cylinder head
with the number 1 cam lobes facing as shown.
IMPORTANT: Each bearing cap has a number and a directional arrow marked on the bearing cap.
2. Install the camshaft bearing caps in their proper locations and direction.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the camshaft bearing cap bolts.
^
Tighten the camshaft bearing cap bolts in the sequence shown to 13 Nm (10 ft. lbs.).
^
Tighten the front bearing cap bolts to 23 Nm (17 ft. lbs.).
4. Install the intake camshaft sprocket (1) to the camshaft.
5. Install the camshaft sprocket bolt (1) in order to secure the cam sprocket.
^
Tighten the camshaft sprocket bolt to 44 Nm (33 ft. lbs.).
