Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
Blower Motor Switch: Service and Repair
Removal Procedure
1. Remove the center console trim bezel.
2. Remove the blower speed selector switch knob by pulling the knob away from the heater control unit.
3. Remove the two screws (5) and pull the heater control (4) unit forward.
4. Remove the illumination bulbs (2).
5. Disconnect the blower speed selector switch electrical connector.
6. Remove two the screws (1) and the blower speed selector switch (3) from the heater control unit.
Installation Procedure
1. Install the blower speed selector switch (3) to the heater control unit. Secure the blower speed selector switch with the two screws (1).
2. Install the illumination bulbs (2).
3. Connect the blower speed selector switch electrical connector.
4. Install the heater control unit (4) to the I/P. Secure with the two screws (5).
5. Install the blower speed selector switch knob.
6. Install the center console trim bezel.