Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
IMPORTANT: A small amount of clutch material in the bottom of the transaxle fluid pan is a normal condition and is consistent with normal
transaxle wear. The bottom of the fluid pan is equipped with a magnet that will collect minute metal filings. However, if large amounts of clutch
material, metal shavings or other foreign matter are present, disassembly and inspection of the transaxle is indicated.
7. Inspect the bottom of the fluid pan for any large pieces of metal or other foreign matter.
8. Clean the fluid filter screen with solvent and dry thoroughly. If the screen mesh is damaged, replace the filter screen.
9. Clean the transaxle fluid pan magnets (2) and the bottom of the transaxle fluid pan (1).
10. Clean the gasket material from the fluid pan-to-case mating surfaces.
INSTALLATION PROCEDURE
1. Install the fluid filter screen gasket (1) and the fluid filter screen (2) to the valve body assembly. Secure the screen with 3 bolts.
^
Tighten the fluid filter screen bolts to 10 Nm (89 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the new transaxle fluid pan gasket and transaxle fluid pan to the transaxle. Secure with 18 bolts.
^
Tighten the transaxle fluid pan bolts to 4.9 Nm (43 inch lbs.).
3. Install the transaxle pan drain plug into the transaxle fluid pan.
^
Tighten the transaxle drain plug to 17 Nm (113 ft. lbs.).
4. Remove the drain pan from under the transaxle.
