Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
1. Connect the accelerator throttle cable (4) to the actuator lever (1).
2. Install the accelerator throttle cable (4) into the bracket.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Secure with one screw (3).
Tighten
Tighten the cable attaching screw (5) to 2 N.m (26 lb in).
4. Install the cruise control actuator cover (1) by applying slight downward pressure to the cover.
5. Connect the accelerator throttle cable (2) to throttle lever (3).
-
Opening the throttle lever by hand will aide in accelerator throttle cable installation.
6. Connect the accelerator throttle cable to accelerator cable bracket.
7. Connect the accelerator throttle cable to the cable guide clip.
8. Adjust the cable adjusting locknuts to allow slight freedom of movement between the accelerator cable and the throttle lever.