chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Underhood Fuse Block Replacement|Page 7121 > < Underhood Fuse Block Replacement
Page 2
background image

^

The torque converter clutch solenoid (4 speed automatic only)

^

The park/neutral position (PNP) switch

^

The reverse lamp switch (manual transmission only)

^

The Evaporative Canister Purge Solenoid Valve

^

The oil pressure switch

^

Both ignition coils

^

The intake air temperature (IAT) sensor

^

The vehicle speed sensor (VSS)

^

The data link connector (underhood)

^

The heated oxygen sensor 1

^

C100 (knock sensor)

^

The fan control switch

^

C8 from fuse and relay block 1

^

C6 from fuse and relay block 1

^

C2 from fuse and relay block 1

4. Remove the front floor console.
5. Disconnect the following instrument panel electrical connectors

^

C212

^

C213

^

C222

^

223

^

Powertrain Control Module (PCM) C1

^

PCM C2

^

PCM C3

^

The noise filter

6. Remove the harness from the interior of the vehicle. Push the harness through the bulkhead grommet into the engine compartment.
7. Disconnect the harness retaining clips.
8. Remove the harness from the vehicle.

INSTALLATION PROCEDURE

1. Install the harness to the vehicle.
2. Connect the harness retaining clips.
3. Install the harness to the interior of the vehicle. Push the harness through the bulkhead grommet into the interior of the vehicle.
4. Connect the following instrument panel electrical connectors:

^

GC212

^

C213

^

C222

^

C223

^

Powertrain Control Module (PCM) C1

^

PCM C2

^

PCM C3

^

The noise filter

5. Install the front floor console.
6. Connect the following underhood electrical connectors:

^

The generator

^

The engine coolant temperature (ECT) sender

^

The crankshaft position sensor

^

The manifold absolute pressure (MAP) sensor

^

The camshaft position sensor

^

The 4 fuel injectors

^

The idle air control (IAC) valve

^

The throttle position sensor (TPS)

^

G105

^

The starter connector

^

The starter wire

^

C101 (A/C compressor clutch) if equipped

^

The battery positive wire from the battery positive terminal

^

The torque converter clutch solenoid (4 speed automatic only)

^

The park/neutral position (PNP) switch

^

The reverse lamp switch (manual transmission only)

^

The Evaporative Canister Purge Solenoid Valve

^

The oil pressure switch

^

Both ignition coils

^

The intake air temperature (IAT) sensor

^

The vehicle speed sensor (VSS)

^

The data link connector (underhood)

Underhood Fuse Block Replacement|Page 7121 > < Underhood Fuse Block Replacement