R 10 P/U 2WD V8-379 6.2L DSL (1988)
Staking Locations
-
Stake 3 places 120 degrees apart.
3. Pulley (26) on the front head.
Installing The Pulley Bearing Assembly
^
Position J 33017 and J 33023 over the inner race of the bearing.
^
Position J 8433-1 on J 33023 and assemble the through bolts and washers through the puller bar slots and thread them into J 33026.
-
The thread of the through bolts should engage the full thickness of the compressor holding fixture.
^
Tighten the center screw in J 8433-1 to force the pulley and bearing assembly onto the compressor front head (33).
-
Should J 33017 become misaligned with the inner race of the bearing, back off J 8433-1 and relocate center, then continue installation.
4. Pulley bearing retainer (24) using J 6083.
5. Clutch plate and hub assembly (22).
Clutch Coil Assembly