R 10 P/U 2WD V8-379 6.2L DSL (1988)
Owners of vehicles recently sold from your new vehicle inventory are to be contacted by the dealer, and arrangements made to make the required
correction according to instructions contained in this bulletin.
This bulletin is notice to you that the new motor vehicles included in this campaign may not comply with the standard identified above. Under Section
108 of the National Traffic and Motor Vehicle Safety Act, it is illegal for a dealer to sell a new motor vehicle which the dealer knows does not comply
with an applicable Federal Motor Vehicle Safety Standard. As a consequence, if you sell any of these motor vehicles without first performing the
campaign correction, your dealership may be subject to a civil penalty up to $1,000 for each such sale.
PARTS INFORMATION
A new certification label required for each vehicle involved will be mailed to owners of record or involved dealers by Chevrolet Motor Division. The
label will contain the VIN and corresponding rim, tire inflation, and loading information.
If the existing label's VIN does not match the new label or the new label was not received, contact your Branch Office to make arrangements to receive a
replacement.
Service, I.D. Label, & Claim Information
SERVICE PROCEDURE
1.
Open driver's door.
2.
Verify that the Vehicle Identification Number (VIN) of the new Certification Label is the same as the existing label. (See illustration included with
sample owner letter).
If the VIN of the new certification label is different than the existing label, contact your Branch Office to arrange to receive the correct label.
If the VIN of the new certification label is the same as the existing label, follow the remaining steps of this procedure and install the new label.
