R 30 P/U 2WD V6-262 4.3L (1987)
Starter Motor: Service and Repair
STARTER MOTOR REPLACEMENT
Remove or Disconnect
- Place the vehicle on a hoist.
1. Negative battery cable.
Starter Motor Mounting On The 2.5L Engine
2. Brush end mounting bracket on the 2.5L engine starter motor.
3. Solenoid wiring.
On the 4.3L, raise the vehicle halfway on the hoist, and reach through the right wheel well.
- Raise the vehicle.
4 Wheel Drive Vehicles:
4. Four bolts on the skid plate (if equipped).
5. Skid plate (if equipped).
8. Bolts and the two brackets holding the brake line to the crossmember.
7. Crossmember (three bolts on each side).
8. Bracket holding the transmission fluid cooler lines to the flywheel housing, brace rod to the flywheel housing and/or the lower flywheel housing if
necessary.
All Models:
9. Two bolts holding the starter to the engine.
10. Starter and the shim (if present).
Install or Connect
Meshing Starter And Flywheel Teeth
