S10/T10 Blazer 2WD L4-119 1.9L VIN A 2-BBL (1984)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder Replace
Fig. 1 Clutch master cylinder
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Sound absorbing panel from upper left side foot well.
3. Lower left side A/C duct (if equipped).
4. Master cylinder pushrod from clutch pedal.
5. Reservoir hose and slave cylinder hydraulic line from master cylinder.
6. Master cylinder retaining nuts.
7. Clutch master cylinder and gasket.
INSTALL OR CONNECT
1. New gasket and master cylinder, then install retaining nuts and torque to 14-20 Nm (10-15 ft lbs).
2. Connect reservoir hose and slave cylinder hydraulic line to master cylinder.
3. Connect master cylinder pushrod to clutch pedal and install retaining clip.
4. Lower left side A/C duct (if equipped).
5. Install sound absorbing panel.
6. Negative battery cable.
7. Fill reservoir and bleed system.