S10/T10 Blazer 2WD V6-262 4.3L (1988)
^
J 8433-1 with through bolts, washers and forcing screw over J 33024.
^
Be sure J 8433-1 and the clutch coil assembly (27) stay "in line" during installation.
Staking The Clutch Coil To The Front Head
^
When the clutch coil assembly (27) is seated on the front head (33) use a 3 mm (1/8-inch) diameter drift punch to stake the head (33) at 3
places, 120 degrees apart to assure the clutch coil assembly (27) remains in position.
Clutch Coil Staking Locations
-
Stake size should be one half the area of the punch tip and 0.28-0.35 mm (0.010-0.015-inch) deep.
2. Pulley (24).
3. Clutch plate and hub assembly (22).