S10/T10 Blazer 2WD V6-262 4.3L (1988)
Figure 3
INSTALL (Figures 2 & 3)
Tools required:
J8092 Drive handle
J33790 Bearing installer and remover
J33833 Bearing installer and remover
1. Front output bearing (61) to the new front case half P/N 15635347 (45) using J 8092 and J 33833.
2. New front output shaft seal P/N 15579788 (72) to the new front case half (45).
3. Front output bearing retainer ring (snap ring) (60) to the new case half.
4. New input seal P/N 14095609 (42) into retainer (44) if it was removed in step 24 above.
5. Input bearing (40) and input bearing retainer (39) to the new case half using J 36372.
6. Planetary carrier (36) and the input gear (38) to the annulus gear (62) using a soft hammer.
7. Retainer snap ring to the input gear (38). Input bearing retainer (44) and input bearing retainer bolts (43) to the front case half (45).
-
Clean mating surfaces and apply RTV or equivalent on bearing retainer mating surfaces.
NOTE Do not block oil feed hole from case to bearing retainer.
-
Apply Loctite 242 (R) or equivalent on bearing retainer bolts.
-
Tighten bolts to 19 N-m (14 lbs.ft.).