S10/T10 Blazer 2WD V6-262 4.3L (1988)
Clutch Master Cylinder: Service and Repair
Removal and Installation
Description
REMOVAL
1. Remove sound absorbing panel from upper left side foot well.
2. Disconnect master cylinder push rod from clutch pedal.
3. Remove master cylinder retaining nuts.
4. Disconnect reservoir hose and slave cylinder hydraulic line from master cylinder.
5. Remove clutch master cylinder.
INSTALLATION
1. Position master cylinder at front of dash, then install retaining nuts and torque to 10-15 ft lbs.
2. Connect master cylinder push rod to clutch pedal and install retaining clip.
3. Install sound absorbing panel.
4. Connect reservoir hose and slave cylinder hydraulic line to master cylinder.
5. Bleed system.
