S10/T10 Blazer 2WD V6-262 4.3L (1988)
Figure 3
REMOVE (Figures 2 & 3)
Tools required:
J8092 Drive handle
J33790 Bearing installer and remover
1. Transfer case from vehicle.
-
Refer to Section 7D of the appropriate S/T Service Manual for complete transfer case removal procedure.
2. Front output flange nut (77), washer (76), rubber sealing washer (75) and front output flange
(74) from the front output shaft.
3. Vacuum switch (46) and O-ring seal (47).
4. Poppet screw (68), O-ring seal (69), poppet spring (71) and poppet plunger (70).
Mainshaft Extension and Oil Pump Housing
5. Rear extension housing bolts (3) and rear extension (4).
6. Bearing retainer (snap ring) (5) from the mainshaft (19).
7. Pump retainer housing bolts (7).
8. Pump retainer housing (8) from the rear case half (17).
9. Speedometer tone wheel (11) from the mainshaft (19).