S10/T10 Blazer 2WD V6-262 4.3L VIN Z (1994)
Rear Door Panel: Service and Repair
Rear Door Trim Panel
Rear Door Power Window Switch Connector
Tool Required: J 38778 Trim Panel Remover
Remove or Disconnect
1. Upper door trim moldings.
2. Door handle bezel.
3. Window regulator handle (if equipped).
4. Trim panel armrest screws.
^ Carefully pry off trim panel armrest screw cover with a flat blade tool to access screw.
5. Trim panel from the door.
^ Pry the retainers from their seats using J 38778.
6. Power window switch connector (if applicable).
Install or Connect
1. Trim panel to the door.
2. Window regulator handle (if equipped).
3. Power window switch connector (if applicable).
4. Trim panel arm rest screws and tighten.
5. Door handle bezel.
6. Upper door trim moldings.
