S10/T10 Blazer 2WD V6-262 4.3L VIN Z (1994)
1. Negative battery cable.
2. Discharge and recover refrigerant from the system.
3. Evaporator (10) from accumulator (6).
4. Compressor hose assembly (3) from accumulator (6).
5. O-ring seals.
-
Cap or plug the open lines.
6. Electrical connectors, as necessary.
7. Screw (38) and bracket (40).
8. Accumulator (6).
-
Install sealing caps if accumulator is not being replaced.
INSTALL OR CONNECT
NOTICE: For steps 2, 5, and 6, refer to "Fasteners" under "Vehicle Damage Warnings."
1. Accumulator (6). Refer to "Refrigerant Oil Distribution," if replacing accumulator. See: Service and Repair
2. Bracket (40) and screw (38).
3. Electrical connectors, as necessary.
4. New O-ring seals.
5. Compressor hose assembly (3) to accumulator (6).
-
Tighten compressor hose (3) to 41 Nm (30 lbs. ft.).
6. Evaporator (10) to accumulator (6).
-
Tighten evaporator (10) to 41 Nm (30 lbs. ft.).
7. Negative battery cable.
8. Refrigerant to the system.
-
Check the system for leaks.
