S10/T10 Blazer 2WD V6-262 4.3L VIN Z (1994)
Pulley Rotor & Bearing Puller Removal
4. Hold the J 33020 Puller in place and tighten the puller screw against the Puller Guide to remove the pulley rotor and bearing assembly.
5. To prevent damage to the pulley rotor during bearing removal, the rotor hub must be properly supported.
Bearing Assembly
Remove the forcing screw from J 33020 Puller and with the puller tangs still engaged in the rotor slots, invert the assembly onto a solid flat surface
or blocks as shown in the illustration.
6. Drive the bearing out of the rotor hub with Rotor Bearing Remover J 9398-A and J 29886 Universal Handle.
Pulley Rotor & Bearing Puller Removal
It is not necessary to remove the staking in front of the bearing to remove the bearing, however, it will be necessary to file away the old stake metal
for proper clearance for the new bearing to be installed into the rotor bore or the bearing may be damaged.
Install or Connect
