chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 601 > < Diagram Information and Instructions|Page 599
Page 4
background image

example, "Section 20" is the engine control section of the manual. 

To navigate through these "Cell" references start at the vehicle level and go to: Diagrams / Electrical Diagrams - for a complete list of the diagrams
available for the vehicle. Choose the system you are working on and view those diagrams. 

Note: If unsure of the system - try utilizing the search feature. Type a component in the search feature that belongs to the system and when the
results are displayed note the path displayed. This will show the system the component belongs in.

Electrostatic Discharge (ESD Sensitive Devices)

Electrostatic Discharge (ESD) Symbol

HANDLING ELECTROSTATIC DISCHARGE (ESD) SENSITIVE PARTS  

Many solid-state electrical components can be damaged by electrostatic discharge(ESD). Some will display a label, but many will not.

NOTE:  In order to avoid possibly damaging any components, observe the following:
1. Body movement produces an electrostatic charge. To discharge personal static electricity, touch a ground point (metal) on the vehicle. This

should be done anytime you:
^

Slide across the vehicle seat.

^

Sit down or stand up.

^

Do any walking.

2. Do not touch exposed electric terminals or components with your fingers or tools. Remember, the connector you are checking might be tied

into a circuit that could be damaged by electrostatic discharge.

3. When using a screwdriver or similar tool to disconnect a connector, never let the tool come into contact with or come between exposed

terminals.

4. Never jumper, ground, or use test equipment probes on any components or connectors unless specified in diagnosis. When using test

equipment, always connect the ground lead first.

5. Do not remove the solid-state component from its protective packaging until you are ready to install the part.
6. Always touch the solid-state component's package to ground before opening. Solid-state components can also be damaged if:

^

They are bumped or dropped.

^

They are laid on any metal benches or components that operate electrically such as a TV radio, or oscilloscope.

Schematic Symbols

Diagram Information and Instructions|Page 601 > < Diagram Information and Instructions|Page 599