S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Speaker: Service and Repair
Speaker Replacement - Front
SPEAKER REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Remove the front speaker grille screws.
2. Remove the radio front speaker grille.
3. Remove the DRL sensor from the right speaker grille, if equipped.
4. Turn the DRL sensor counterclockwise 1/4 turn in order to remove.
5. Remove the radio front speaker screws.
6. Remove the radio front speaker.
7. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the radio front speaker.
3. Install the radio front speaker screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the radio front speaker screws to 1.9 N.m (17 lb in).
4. Install the DRL sensor to the right speaker grille, if equipped.
