S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Front Door Weatherstrip: Service and Repair
Weatherstrip Replacement - Door Opening
Weatherstrip Replacement - Door Opening
Removal Procedure
1. Remove the door opening weatherstrip from the door opening.
2. Gently pull the weatherstrip from the pinch weld flange.
Installation Procedure
1. Install the door opening weatherstrip to the door opening.
2. Position the pre-formed corner of the weatherstrip in the upper rear corner of the door opening.
3. Push the weatherstrip onto the pinch weld flange.
Start at the pre-formed corner and work around the entire edge of the door opening.