S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Rear Door Panel: Service and Repair
Panel Replacement
Trim Panel Replacement - Side Rear Door (Utility)
Trim Panel Replacement - Side Rear Door (Utility)
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Remove the window weatherstrip.
2. Remove the door handle bezel.
3. Remove the window regulator handle, if equipped.
4. Remove the power window switch, if equipped.
5. Remove the trim panel screws from the armrest. Carefully pry off the cover using a flat-bladed tool.
6. Use the J 38778 in order to release the door trim panel retainers.
7. Remove the door trim panel from the door.
Installation Procedure
1. Install the door trim panel to the door.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the trim panel armrest screws to the armrest.
Tighten the screws to 1.9 N.m (17 lb in).
3. Position the cover and snap the cover into place.
4. Install the power window switch, if equipped.
5. Install the window regulator handle, if equipped.
6. Install the inside door handle bezel.
7. Install the window weatherstrip.
Rear Side Door Trim Panel Replacement
TRIM PANEL REPLACEMENT - SIDE REAR DOOR (UTILITY)
TOOLS REQUIRED
J 38778 Door Trim Pad and Garnish Clip Remover
