S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
3. Remove the front side door lock pillar garnish molding from the vehicle. Feed the seat belt through the garnish molding.
INSTALLATION PROCEDURE
1. Install the front side door lock pillar garnish molding to the vehicle. Feed the seat belt through the garnish molding.
2. Install the upper and the lower front seat belt anchor bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 70 N.m (52 lb ft).
3. Install the front and the rear door sill trim plates.
Garnish Molding Replacement - Windshield Pillar
GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR
TOOLS REQUIRED
J 38778 Door Trim Pad and Garnish Clip Remover
REMOVAL PROCEDURE
