S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
16. Discard the rubber O-rings.
Installation Procedure
1. If reusing the brake caliper pin bolts and retainers, clean the brake caliper pin bolts and retainers using denatured alcohol, or equivalent.
2. Dry the brake caliper pin bolts using non-lubricated, compressed filter air.
3. Lubricate the sleeves and bushings with Delco Silicone Lube, GM P/N 18010909, or equivalent.
4. Install the rubber O-ring bushings to the brake caliper.
5. Install the brake caliper mounting bolt sleeves.
6. Install the brake pads to the brake caliper.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the brake caliper mounting bolts.
Tighten the brake caliper mounting bolts to 51 Nm (38 ft. lbs.).
Notice: Refer to Brake Hose Installation Notice in Service Precautions.
Important: When performing the following service procedure, DO NOT reuse the washers, replace them with new washers.
