S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
2. Install the brake caliper bolt to the brake caliper.
Tighten the brake hose bolt to 44 Nm (32 ft. lbs.).
3. Remove the plug or cap from the exposed brake pipe fitting.
4. Install the brake hose to the brake pipe.
Important: Ensure that the brake hose is not twisted and does not come in contact with any of the suspension components.
5. Using a backup wrench on the brake pipe fitting, tighten the brake hose fitting.
Tighten the brake hose fitting to 17 Nm (13 ft. lbs.).
6. Install the brake pipe retaining clips.
7. Bleed the hydraulic brake system.
8. Install the tire and wheel assembly.
9. Lower the vehicle. Refer to Vehicle Lifting.
