S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
9. Disconnect the rear park brake cable from the park brake level, left side shown.
10. Collapse the park brake cable locking finger at the backing plate.
11. Remove the park brake cable from the backing plate.
12. Remove the rear park brake cable from the vehicle,
Installation Procedure
Important: When routing the cables through the guide loop, route the left side cable first.
1. Install the park brake cable in the chassis and rear axle housing retainers.
Important: When performing the following service procedure, ensure that the locking fingers for the park brake cable are fully seated against the
backing plate.
2. Install the rear park brake cable in the backing plate.
3. Install the park brake cable in the park brake level.
