S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
4. Connect the steering wheel module yellow 2-way connector (1) located left of the steering column near the knee bolster.
5. Install the CPA to the steering wheel module yellow 2-way connector (1) located near the knee bolster.
6. Install the SIR fuse to the I/P fuse block (1) located in the I/P fuse block.
7. Install the knee bolster.
8. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
8.1.
The AIR BAG indicator will flash 7 times.
8.2.
The AIR BAG indicator will then turn OFF.
9. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
