S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Throttle Position Sensor: Service and Repair
Throttle Position (TP) Sensor Replacement
REMOVAL PROCEDURE
1. Remove the throttle body.
2. Remove the mounting screws from the throttle position (TP) sensor.
3. Remove the TP sensor from the throttle body assembly.
NOTE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.
INSTALLATION PROCEDURE
1. Place the TP sensor over the throttle shaft and align the TP mounting holes with their corresponding holes in the throttle body assembly.