S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Accelerator Pedal: Service and Repair
ACCELERATOR CONTROLS PEDAL REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left closeout/insulator panel.
2. Lift upward on the accelerator pedal in order to relieve tension on the cable.
3. Remove the retainer from the pedal lever hole by compressing the tabs on the retainer.
4. Remove cable from the slot in the pedal lever (1).
5. Remove the accelerator pedal mounting nuts (2).
6. Remove the accelerator pedal assembly.
INSTALLATION PROCEDURE
IMPORTANT: The accelerator cable must not be kinked or damaged in any way during installation.
Ensure that the mounting surface between the accelerator pedal assembly and the bulkhead is free of insulation. The carpet and padding in the pedal
area must be positioned to lay flat and be free of wrinkles and bunches. Wire, hoses, cables, and other flexible components should not be within 13
mm (0.52 in) of the cable or lever, at any point in their travel.
