chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

ABOUT US
Underhood Electrical Center or Junction Block Replacement|Page 148 > < Underhood Electrical Center or Junction Block Replacement

S10/T10 Blazer 2WD V6-4.3L VIN X (2003)

Page 2
background image

6. Loosen the bolts that secure the electrical connectors to the bottom of the underhood electrical center.

7. Disconnect the electrical connectors from the underhood electrical center.
8. Remove the underhood electrical center from the vehicle.

INSTALLATION PROCEDURE

1. Connect the electrical connectors to the underhood electrical center.

NOTE:  Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the electrical connector to the underhood electrical center bolts to 7 N.m (62 lb in).

Underhood Electrical Center or Junction Block Replacement|Page 148 > < Underhood Electrical Center or Junction Block Replacement