S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Power Seat Switch: Removal and Replacement
Seat Switch Replacement - Power
Removal Procedure
1. Remove the seat from the vehicle.
2. Remove the 3 screws securing the trim panel to the seat.
3. Disconnect the electrical connector from the switch.
4. Remove the switch from the trim panel by snapping the switch out of the plastic retaining tabs.
5. Remove the switch assembly.
Installation Procedure
1. Install the switch assembly to the trim panel by snapping the switch into the plastic retaining clips.