S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
6. Disconnect the wires from the solenoid.
7. Remove the starter from the vehicle.
Note the location of the shims, if equipped.
INSTALLATION PROCEDURE
1. Connect the wires to the solenoid.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
-
Tighten the battery positive cable nut to 9 N.m (80 lb in).
-
Tighten the engine wiring harness to starter nut to 1.9 N.m (17 lb in).
