S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
3. Position the rear tie rod in the axle bracket.
Notice: Refer to Fastener Notice in Service Precautions.
4. Loosely install the following parts to the frame bracket:
^
The bolt
^
The washers
^
The nut
^
Tighten the rear tie rod to axle bracket nut to 61 Nm (45 ft. lbs.).
^
Tighten the tie rod to the frame bracket nut to 61 Nm (45 ft. lbs.).
5. Remove the rear axle support.
6. Lower the vehicle.
