S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Clutch Slave Cylinder: Service and Repair
Concentric Slave Cylinder
Removal Procedure
1. Remove the transmission.
2. Remove the 2 bolts securing the concentric slave cylinder to the clutch housing.
3. Remove the slave cylinder from the transmission input shaft.
If required, the bearing can be removed from the slave cylinder for replacement.
Installation Procedure
1. Position the slave cylinder to the transmission input shaft. Ensure that the bleed screw and the coupling are positioned toward the transmission
ports.
Notice: Refer to Fastener Notice in Service Precautions.
2. Secure the concentric slave cylinder to the clutch housing with 2 bolts.
^
Tighten the bolts to 8 Nm (71 inch lbs.).
3. Install the transmission.
