S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Flex Plate: Service and Repair
Engine Flywheel Replacement
Removal Procedure
1. Remove the transmission.
2. Remove the clutch assembly, if equipped.
3. Remove the engine flywheel bolts.
4. Remove the engine flywheel (automatic transmission) (1), if applicable.
5. Remove the engine flywheel (manual transmission) (2), if applicable.
Important: If replacing the engine flywheel (manual transmission), then NEW flywheel weights must be installed into the NEW engine flywheel
in the same location as the old flywheel weights in the old engine flywheel.
6. Note the position of any flywheel weights for assembly (if applicable).
7. Clean and inspect all parts.
Installation Procedure
Important: If replacing the engine flywheel (manual transmission), note the position and length of the original flywheel weights (if applicable).
Flywheel weights of the same length must be installed into the new engine flywheel in the same location as the old flywheel weights were in the old
engine flywheel.