S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
4. Install the front bearing retainer and the 6 bolts to the transmission.
^
Tighten the 6 bearing retainer bolts to 14 Nm (10 ft. lbs.).
5. Install the clutch actuator and the bolts.
^
Tighten the clutch actuator bolts to 8 Nm (71 inch lbs.).
6. Install the transmission.
Transmission Housing Oil Seal Replacement - Rear
Transmission Housing Oil Seal Replacement - Rear
^
Tools Required
-
J 23129 Universal Seal Remover
-
J 6125-1B Slide hammer
-
J 36503 Seal Installer
Removal Procedure