S10/T10 Blazer 4WD L4-119 1.9L VIN A 2-BBL (1983)
FIGURE 1 - LOCK LATCH INSTALLATION PROCEDURE
To install the new positive lock latch, the following is the procedure:
1.
With the seat back in the up position, remove the forward seat anchor nut from the right and left sides. Figure 1.
2.
Pivot the rear seat back forward.
3.
Remove the rear seat anchor nut from both sides. Figure 1.
4.
On the right side (Passenger) only. Remove the plastic cover from the latch arm which is connected to the seat back.
5.
On the right side (Passenger) only. Remove the four(4) bolts attaching the latch to the seat back and bottom. Figure 1. Raise the rear of the seat
assembly to remove latch. Support the seat in this position.
FIGURE 2 - LOCK LATCH INSTALLATION PROCEDURE
6.
With the assembly raised, inspect for the presence of a flat washer on both rear seat anchor studs. Remove the washers (if present) from both sides
and discard. Figure 2.
