Chevrolet Blazer 4WD L4-119 19L Steering Gear Service and Repair
Fig. 23 Stub shaft & rack positioning. Model 605
d. Check relation of stub shaft and rack piston by threading worm and valve into rack piston until valve face and rack piston face are flush.
Referring to
Fig. 23, flats on stub shaft and piston must be parallel. If not parallel, disassemble and repeat steps b and c.
Model 605 Steering Gear Assembly
Fig. 12 Pitman shaft seals & bearings. Model 605
Fig. 27 Pitman shaft bearing installation. Model 605
1.
If pitman shaft needle bearing was removed, install with lettered edge facing outward and flush with bottom of counter bore with a suitable tool,
Fig. 27.
2.
Install pitman shaft oil seal, washer and snap ring,
Fig. 12.
Fig. 9 Lower thrust bearing & adjuster assembly. Model 605
