S10/T10 Blazer 4WD L4-137 2.2L DSL (1984)
Brake Caliper: Service and Repair
Installation
For additional information see Installation Notes. See: Fundamentals and Basics
Retracting Piston
1. Retract piston in caliper bore and position caliper over disc, lining up holes in caliper with holes in mounting bracket. If brake hose was not
disconnected during removal, be sure not to kink it during installation.
Caliper Mounting Bolts
2. Start mounting bolts through sleeves in inboard caliper ears and the mounting bracket, making sure ends of bolts pass under ears on inboard pad.
NOTICE: If the caliper was removed for service, make sure it is installed on the correct knuckle. The caliper bleed screw should be positioned on
top of caliper when assembled on vehicle.
3. Push mounting bolts through to engage holes in the outboard ears. Then thread mounting bolts into bracket.
4. Torque mounting bolts to 50 Nm (37 ft lb).