S10/T10 Blazer 4WD L4-137 2.2L DSL (1984)
Figure JBlazer
SECOND SEAT INSTALLATION
1.
Drill a 8 mm (5/16") diameter hole through the floor pan 140 mm (5.50") forward of the rear edge of the floor pan and on the center of the
depressed floor pan rib (View A - Figure J).
A.
Left Seating Position - 1,330 mm (52.25") inboard of the right quarter inner panel. Refer to illustration.
2.
To insure proper sealing of the hole, remove any dirt or foreign matter from around the hole on the underside of the floor pan where the sealer is to
be applied.
3.
Place sealer on the hole from the underside of the vehicle and assemble the bolt, anchor bracket, anchor plate, and lock nut to the floor pan as
shown in View A. Tighten securely and make certain that the hole is completely sealed. Do not make the anchor installation without properly
sealing the assembly.