S10/T10 Blazer 4WD L4-137 2.2L DSL (1984)
Neutral Safety Switch: Service and Repair
Manual Transmission
Fig. 5 Clutch start switch installation
Removal
1. Remove the hush panel from inside the vehicle.
2. Dosconnect the electrical lead from the switch.
3. Remove the mounting screw from the bracket and disconnect the switch from the clutch pedal.
Installation
1. Connect the switch to the clutch pedal.
2. Position the switch to the bracket and install mounting screw. Toruq to specifications.
3. Adjust neutral safety switch as follows.
a. Position slider forward on switch shaft.
b. Fully depress clutch pedal to the floor mat and/or carpet to set the switch.
4. Install the hush panel.