S10/T10 Blazer 4WD V6-262 4.3L (1989)
Figure 1
8.
Make the following connections (see Figure 1).
^
Red wire to terminal E of high blower motor relay connector and to the junction block connection located on the cowl.
^
Black wire to blower motor case mounting bolt for chassis ground. Choose the nearest bolt and scrape lightly around the bolt hole to assure
a good ground.
^
Remaining end of black wire to terminal A of high blower motor relay connector
^
Brown wire to terminal D high blower relay connector and terminal 52 of resistor block.