S10/T10 Blazer 4WD V6-262 4.3L (1989)
10.
Remove parking brake cable grommet (# 9 Figure 1).
11.
Remove bolt & clamp (# 10 Figure 1) in engine compartment.
12.
Raise vehicle.
13.
Pinch parking brake cable retainer ears (# 11 Figure 1) inward.
14.
Pull cable out of frame.
15.
Lower vehicle and remove parking brake cable.
Installation
1.
Route new parking brake cable behind dash and feed cable through grommet opening in body (#9 Figure 1).
2.
Attach cable to parking brake lever.
3.
Attach parking brake lever to steering column and place in the full apply position.
4.
Attach hood cable handle to dash panel.
5.
Install parking brake cable grommet into body opening.
6.
Attach front panel.
7.
Raise vehicle.
8.
Insert cable through frame.
9.
Attach parking brake cable to equalizer.
10.
Install equalizer nut.
11.
Adjust parking brake cable per Procedure A.
12.
Lower vehicle.
13.
Install and tighten set screw when adjustment is complete.
Parts Information:
Parts are expected to be available on December 5, 1988. Until then, normal part orders will not be accepted by GMSPO. Only verifiable emergency VIP
orders will be accepted. SPO will make every effort to obtain parts. All parts will be placed on 400 control to waive VIP surcharges. However, the part
will be shipped premium transportation at dealer's expense. All other order types will be canceled as incorrectly ordered while the 400 control is in place.
Parts Required:
Part Number
Description
Quantity
15602898
Front
1
Labor time to perform this procedure is .8 hours.
Use Labor Op:
T1406
