S10/T10 Blazer 4WD V6-262 4.3L (1989)
Removing The Bearing From The Pulley Rotor Assembly
4. Pulley bearing (25) from the pulley (26) using J 9398-A and J 29886.
^
Remove the forcing screw from J 33020 and with the puller tangs still in place in the pulley slots, turn the assembly upside down onto a flat
surface.
^
When removing the old pulley bearing (25) allow the staking to remain, then file away the old staked metal for proper fit when installing a new
bearing (5) in the pulley bore.
Install or Connect
Tools Required:
J 6083 Snap Ring Pliers
J 8433 Puller Bar
J 9481-A Pulley Bearing Installer
J 21352-A Support Block
J 29886 Threaded Driver Handle
J 33017 Pulley and Bearing Assembly Installer
J 33019 Bearing Staking Tool (with staking pin and retaining band)
J 33023-A Puller Pilot
J 34992 Compressor Holding Fixture