S10/T10 Blazer 4WD V6-262 4.3L VIN Z (1994)
Removing The Internal Snap Ring
3. External front housing snap ring with J 6435.
4. Rotor pulley assembly.
-
Insert J 37828 into the groove
Removing The Rotor Pulley
-
Insert J 37827 over the exposed shaft.
-
Align the thumb head bolts of J 8433 to the puller fingers and tighten.
Removing The Rotor Pulley (2 Of 2)
-
Turn the puller center bolt to the right with a socket wrench until the rotor pulley is free.
5. Clutch coil.
-
Loosen the coil lead wire from the clip on top of the compressor front housing.